Blog · Retaining walls · 9 min read

Retaining Wall Cost: Why Height Matters More Than Material

LA retaining walls average about $7,100. See costs by material, height and length, when a wall needs a permit and an engineer, and what raises a bid.

Retaining Wall Cost: Why Height Matters More Than Material

Picture two backyards with the same 40 feet of wall and the same concrete block. In the first, the wall is 3 feet tall on nearly flat ground, edging a planter. In the second, it is 5 feet tall and holds up a slope with a patio on top. The block costs about the same per foot. The bills do not. The second wall needs a permit, engineered plans, a bigger footing, reinforcement and real drainage.

That is the part most cost guides skip. They sort walls by material, but in Los Angeles the height of the wall and what it holds up decide whether you need a permit and an engineer, and those decide the price. This guide covers LA costs, the height and permit rules, costs by material and size, and what to check in a bid.

The short answer: retaining wall costs at a glance

ItemTypical costSource
Los Angeles average$7,140 (range $2,674 to $11,842)Angi LA
National average$6,085 (most pay $3,192 to $9,208)Angi
Per square foot, installed$35 to $65 on averageHomeGuide
Per linear foot (2 to 6 ft tall)$40 to $360 or moreAngi
LA labor$60 to $90 per hourAngi LA
Structural engineering, typical LA wall$415 to $875Angi LA
Drainage excavation, LA$70 to $80 per linear footAngi LA
Permits$50 to $450Angi
Removing an old wall$10 to $20 per linear footAngi

What a retaining wall costs in Los Angeles

Angi puts the Los Angeles average at $7,140, with a range of $2,674 to $11,842, and says that is 15% more than the national average. National guides land close to each other: Angi and HomeAdvisor both put the national average at $6,085, and LawnStarter puts it at $6,300, with most people paying $3,500 to $9,400.

Labor is the biggest share. HomeGuide says labor is 40% to 60% of the total cost, and Angi's LA page puts local labor at $60 to $90 per hour, or $20 to $60 per square foot. HomeGuide also notes a project minimum of $1,500 to $3,000, so even a short wall rarely comes in at a few hundred dollars once a crew shows up.

The 4-foot line: permits and engineering

This is where the price really forks. In unincorporated LA County, a retaining wall is exempt from a building permit only if it retains "not over 4 feet in height measured from the bottom of the footing to the top of the wall, unless supporting a surcharge or impounding a Class I, II, or III-A liquids." Note the measurement: it starts at the bottom of the footing, not at the ground, so a wall that looks 3.5 feet tall can be over the line. And a surcharge, such as a driveway, a slope or a building above the wall, changes the answer at any height. County Public Works lists "retaining walls of any height supporting a surcharge or slope" among the work that needs a permit.

In the City of Los Angeles, LADBS publishes an information bulletin for retaining and slough walls 4 feet high or less with three standard designs. The bulletin says "No building permit is required for Figure 1", a low wall that cannot go where the slope below is steeper than 20 percent, while "Permit is required for Figure 2 and Figure 3." It also warns that these designs "may not be suitable in all cases" and that for extensive walls "a licensed civil or structural engineer should be consulted."

What engineering costs. The cost guides agree on the trigger. Angi lists structural engineering as required for walls over 4 feet, and This Old House says that "for walls over four feet tall or those supporting significant loads," the calculations should be done by a licensed engineer. The price depends on the site:

Walls at the street. A wall in or next to the public right-of-way follows a different track. The City's Bureau of Engineering says walls over 2 feet require a "B" Permit for plan and structural approval there, and that its standard plans allow retaining walls up to 6 feet in height.

Cost by material

Material matters, just less than height. Here are installed costs per square foot from two national guides, with Angi's LA averages alongside. For design ideas by material and yard, see retaining wall ideas. If you plan to build a small wall yourself, our guide on how to build a retaining wall walks through each step.

MaterialHomeGuide (per sq ft)LawnStarter (per sq ft)Angi LA average (per sq ft)
Vinyl$10 to $20$10 to $15$15
Wood or timber$15 to $30$13 to $35$27.50
Concrete block$15 to $40$15 to $40 (cinder block)$47.50 (concrete, block or poured)
Poured concrete$20 to $45$20 to $40
Brick$30 to $60not listed$27.50
Natural stone$20 to $95$20 to $90$75
Steel$40 to $150$75 to $150 (Corten)$97.50

Sources: HomeGuide, LawnStarter, Angi LA. LawnStarter also lists interlocking blocks at $15 to $35 and gabion at $10 to $40 per square foot.

Durability is part of the price. HomeAdvisor says wood lasts 5 to 20 years, concrete 50 to 100 years, and stone up to 200 years. A cheap timber wall that has to be rebuilt later is not always the cheaper wall.

Illustration comparing a short retaining wall with a taller reinforced wall holding a slope and driveway

Cost by height and length

Per-foot pricing climbs with height. HomeAdvisor puts walls at $40 to $200 per linear foot for 2-foot walls and about $360 per linear foot for 6-foot walls. The taller wall is not just more of the same block. In our experience it needs a deeper, wider footing, steel reinforcement, more excavation and more drainage, and once it crosses the permit line it adds plans and inspections.

For length, Angi's LA figures give a feel for typical jobs:

Per square foot of wall face, HomeGuide puts the average at $35 to $65, including materials and labor, and Forbes Home puts materials and labor combined at $10 to $100 per square foot. The wide ranges are the height effect again: the same square footage costs more when it is tall and loaded.

The line items that raise a bid

Repair or replace?

If you already have a wall, a repair may be enough. Angi puts the average retaining wall repair at $700, with a range of $450 to $950. Some walls are past that point. Angi lists shallow footings, lack of weep holes, significant leaning, and wide cracks as signs a wall may not be worth repairing, and warns that left alone, "soil erosion will amplify until the wall eventually collapses or falls over completely." A leaning wall that holds up a slope or driveway deserves an engineer's look before anyone quotes a patch.

Contractor checking a leaning, cracked concrete block retaining wall in a Los Angeles backyard

How to compare retaining wall bids

  • Height, measured correctly. Ask for the height from the bottom of the footing to the top of the wall.
  • What the wall holds up. A slope, driveway, pool or house above the wall changes the permit and the design.
  • Permit and plans. Who pulls the permit, from which department, and whether engineering is in the price.
  • Footing and reinforcement. Footing size and steel should match the plans, not a guess.
  • Drainage. Gravel backfill, a drain pipe and weep holes or an outlet should be spelled out. Our retaining wall drainage guide covers what to check before backfill.
  • Demolition and haul-off. If an old wall is coming out, is removal included?
  • License. Check the contractor on the CSLB license lookup.

DIY versus a contractor. LawnStarter puts DIY materials at $4 to $20 per square foot plus about $157 in equipment, compared with $20 to $53 per square foot installed by a pro, and Angi notes hardscape contractors charge $15 to $50 per square foot for labor, which is what DIY saves. That math works for a low garden wall. Above the permit line, or with a slope or driveway on top, you still need the permit and often engineered plans, so the savings shrink exactly where the wall costs the most.

Medici Construction Group is one licensed option for retaining walls, holding California A, B and C-10 licenses under CSLB #1114433. Whoever you hire, settle the height and the load first, then compare materials.

Frequently asked questions

How much does a retaining wall cost in Los Angeles?

Angi puts the LA average at $7,140, with a range of $2,674 to $11,842. Height, what the wall holds up, and site access move the number most.

Do I need a permit for a retaining wall in Los Angeles?

Often. In unincorporated LA County, walls over 4 feet measured from the bottom of the footing, or any wall supporting a surcharge or slope, need a permit. In the City of Los Angeles, LADBS requires a permit for two of its three standard low-wall designs. Check with your building department before you build.

When does a retaining wall need an engineer?

Cost guides and This Old House point to walls over four feet tall or those supporting significant loads. Angi's LA page puts structural engineering at $415 to $875 for a typical wall; hillside work costs more.

What is the cheapest retaining wall material?

Vinyl and timber are usually cheapest to install, at about $10 to $20 and $15 to $30 per square foot per HomeGuide. They also have shorter lives than concrete or stone.

How much does a retaining wall cost per square foot?

HomeGuide puts the average at $35 to $65 per square foot, including materials and labor. Individual materials run from about $10 for vinyl to $150 for steel.

How long does a retaining wall last?

HomeAdvisor says wood lasts 5 to 20 years, concrete 50 to 100 years, and stone up to 200 years. Drainage and a proper footing matter as much as the material.

Does a retaining wall add value to a home?

It can. Angi's LA page says a retaining wall can raise home value by up to 15%, mostly by making a sloped yard usable. Treat that as a best case, not a promise.

Let's talk about your project

Have a project like this?

Request a bid, or call. A decision-maker answers.

(818) 237-8888